Specifications

MITSUBISHI Digital Color Printer CP-D80DW series
9
Operating directions for customer’s purpose
1. When you want to adjust the color of the print image.
Set the following settings in “Feature Sets” of “Printer Features” in the Print dialog.
(Note that the effects are invalid on the display even if you make following setting.)
1) When you want the density of entire print picture to be thick (dark), decrease the value of “Brightness”.
2) When the print picture is out of focus (the contrast is weak), increase the value of “Contrast”.
The contrast becomes stronger.
3) When you want to change the color of printout.
Change the value of “Brightness”.
Increase Red :Increase the “R” value.
Increase Green :Increase the “G” value.
Increase Blue :Increase the “B” value.
2. When “10x15x2 Type 1” is selected in “Paper size”
Lay out the image 1 and image 2 as following and print them.
x
yz
Y
y
Image 2
Image 1
3. When “5x15x2 Type 1” is selected in “Paper size”
Lay out the image 1 and image 2 as following and print them.
x
y
y
Y
Image 2
Image 1
4. When “5x15x2 Type 2” is selected in “Paper size”
When multiple images are selected in “Preview”, etc., the images are printed in 5x15 (2x6”) size.
When the number of pages or copies is odd, the last print of 5x15 (2x6”) size paper is output as a blank
page. Depending on the application software, a blank page may be set every other page.
Prohibition matter
We prohibit Reverse Engineering, decompiling or reverse assembling of this driver software.
Exemption from responsibility
Occasionally, this software does not operate normally depending on operating environment.
Moreover, Mitsubishi Electric Co. will not assume any responsibility for damage (including, but not limited
to, lost profi t or damage caused from special circumstances etc.) occurring during the use of this driver.
Print dots
Y 2730
x 1864
y 1228
z 1266
Print dots
Y 1228
x 1864
y 614