Specifications

MITSUBISHI Digital Color Printer CP-D80DW series
7
Notes
1) Secure of Hard disk for spool file
Secure the capacity of Hard disk for spool file enough for the printer operation and the number of
printing sheets.
The printing cannot be correctly carried out when the capacity is running short.
The drive for spool file is the same drive as the system drive usually.
2) Operation of the printer
Refer to the operation manual of the printer.
Do not turn off the power switch during data transfer or print.
If you turn off the power switch, restarting of a computer may be needed.
When deletion of a printing data cannot be performed, restarting of a computer is required.
3) About connection of a computer and a printer
Do not disconnect the interface cable during data transfer.
If the interface cable is disconnected, wait 1 minute or more after disconnecting the cable to connect
it again. If the cable is connected without leaving an enough interval, the printer driver may not work
correctly.
4) System requirements for USB interface
Use a personal computer that are USB-guaranteed by the manufacturer.
CP-D80DW series printer supports USB 2.0 (Hi-Speed USB) interface. As USB 2.0 is fully upward-
compatible with USB 1.1, CP-D80DW series printer can be used with a personal computer that supports
USB 1.1 interface.
To use CP-D80DW series printer based on USB 2.0 (Hi-Speed USB), connect with a personal computer
that supports USB 2.0 (Hi-Speed USB). For USB 2.0 (Hi-Speed USB) compatibility of your personal
computer, contact the manufacturer of the personal computer.
5) Connection of USB cable
When you take out and insert a USB cable after installation of a printer driver, wait 10 seconds or more
after extracting a cable.
If the cable is reinserted without leaving an interval, the printer may not operate normally.
6) Print job
Do not delete the print job in the spooler during data transfer. When deleting it, do not start printing until
the printer becomes to the initial status.
7) Number of prints
With some applications, the number of prints set by the printer driver does not work. Set the number of
prints from the print dialog box of the application.
8) Errors during printing
When an error occurs during printing, it may not be displayed on the monitor. Check the indicator on the
front of the printer and take the countermeasure, and then start printing procedure again. For the indica-
tion by the indicator of the printer and the countermeasure, see the operation manual of the printer.
9) When “Resume Job” is selected after “Hold Job” is performed in the Print Queue screen, an error may
not be displayed even if it occurs. In this case, select “Hold Job” and resolve the error, then click “Resume
Job” to resume printing.
10) “Add” of the “Printer List”
In some version of Mac OS X, you may not print images with the printer registered by the “Add” button.
Make the computer recognize the printer by the procedure described in “Installation.”
11) When the printer is turned off or a USB cable is not connected to the printer, the printer stauts may be
displayed as standby. However, it does not affect the further printing oprations.
12) In Mac OS X 10.6, when an error job is deleted without resolving the error, the error indication in the Print
Queue may not be cancelled even if the error is resolved. In this case, delete the printer from the printer
list, and then add it again to cancel the error indication.