Installation guide

7
Removing the drive cradle
In order to install SIMMs it is necessary to remove the drive
cradle. With the side panel removed as described in
Removing the side panel the drive cradle can be removed
as described below:
1. Undo the eight thumbscrews that secure the drive
cradle.
HANDHOLD
HANDHOLD
DRIVE CRADLE
SECURING
THUMBSCREWS
PIVOT PINS
DRIVE CRADLE
SECURING
THUMBSCREWS
SIGNAL
CABLE
POWER
CABLE
2. Disconnect the power cable(s) from the power
supply, and the signal cable(s) from the connectors
on the drive cradle.