Installation guide

6
Removing the side panel
To install any of the add-ons described here it is necessary
to obtain access to the motherboard. This requires the
removal of the left side panel as described below:
1. Prepare the system unit as described above.
2. Unlock the security lock on the rear panel.
3. Unscrew the two thumbscrews.
DISCONNECT FROM SUPPLY AND ISOLATE
BATTERY BEFORE SERVICING OR
REMOVING COVERS
VOR WARTUNG DES GERATES ODER
ENTFERNEN DER GEHAUSEDECKEL
NETZSTECKER ZIEHEN UND
BATTERIE ISOLIEREN
RECONNECTEUR DU SECTEUR ET
ISOLER LA BATTERIE AVANT
L'OUVERTURE DU PANNEAU DE COTE
OU TOUTE INTERVENTION SUR LA MACHINE
REFER TO INSTALLATION INSTRUCTIONS
BEFORE CONNECTING TO SUPPLY
VOIR LA NOTICE D'INSTALLATION
AVANT DE RACCORDER AU RESEAU
VOR ANSCHLIEBEN DES GERATES DIE
BEDIENUNGS-ANLEITUNG LESEN
O
I
BATTERY ISOLATION
SWITCH
AKKUMULATOR -
TRENNSCHALTER
INTERRUPTEUR
D'ISOLATION
DE LA BATTERIE
AC INPUT
100V-120V 6.0A 220V-240V 3.0A
50-60Hz
~
~
THIS APPLIANCE
MUST BE EARTHED
ANTI-STATIC
GROUND POINT
SERIAL
PARALLEL
VIDEO
6 1 2 3 4 5 7 8
KEYBOARD
MOUSE
UPS STATUS
:
:
:
^
/
CASING THUMBSCREWS
APRICOT COMPUTERS
LIMITED
a divisional company
MITSUBISHI ELETRIC
UK LIMITED
ATTACH SERIAL No
LABEL HERE
A DJNVJCCCKCKCZCKZCOZCZFXVGFCV
CKLCKCCKCKCKC OO9D0DQVVVCCCX
HADCUCIHUXCBBBLFR3JASDXJDXIOJIDS
IDHCUASDHJCAGBBKLKIODJADXASSXQ
PUOASDAICJASIJCASIDAICAS
4. Slide the panel back about 15mm to free it from
the lugs.
5. Lift the panel off.