Installation guide

5
Preparing the system unit
Before any add-ons can be installed, the system unit must
be powered down and disconnected from the power
supply, as described earlier. It must also be resting flat on
the right side panel on a suitable work surface with the
appropriate antistatic measures taken. As shown below:
DISCONNECT FROM SUPPLY AND ISOLATE
BATTERY BEFORE SERVICING OR
REMOVING COVERS
VOR WARTUNG DES GERATES ODER
ENTFERNEN DER GEHAUSEDECKEL
NETZSTECKER ZIEHEN UND
BATTERIE ISOLIEREN
RECONNECTEUR DU SECTEUR ET
ISOLER LA BATTERIE AVANT
L'OUVERTURE DU PANNEAU DE COTE
OU TOUTE INTERVENTION SUR LA MACHINE
REFER TO INSTALLATION INSTRUCTIONS
BEFORE CONNECTING TO SUPPLY
VOIR LA NOTICE D'INSTALLATION
AVANT DE RACCORDER AU RESEAU
VOR ANSCHLIEBEN DES GERATES DIE
BEDIENUNGS-ANLEITUNG LESEN
O
I
BATTERY ISOLATION
SWITCH
AKKUMULATOR -
TRENNSCHALTER
INTERRUPTEUR
D'ISOLATION
DE LA BATTERIE
AC INPUT
100V-120V 6.0A 220V-240V 3.0A
50-60Hz
~
~
THIS APPLIANCE
MUST BE EARTHED
ANTI-STATIC
GROUND POINT
SERIAL
PARALLEL
VIDEO
6 1 2 3 4 5 7 8
KEYBOARD
MOUSE
UPS STATUS
:
:
:
^
/
BENCH
WRIST STRAP
BENCH MAT
APRICOT COMPUTERS
LIMITED
a divisional company
MITSUBISHI ELETRIC
UK LIMITED
ATTACH SERIAL No
LABEL HERE
A DJNVJCCCKCKCZCKZCOZCZFXVGFCV
CKLCKCCKCKCKC OO9D0DQVVVCCCX
HADCUCIHUXCBBBLFR3JASDXJDXIOJIDS
IDHCUASDHJCAGBBKLKIODJADXASSXQ
PUOASDAICJASIJCASIDAICAS
In the instructions that follow, it is assumed that the system
unit is resting on its side panel and that the reader is
viewing the system unit from the front, with the drive cradle
door to the right, as shown above.