Installation guide

2. Position the SIMM above the socket with the SIMM

tilted slightly towards the rear of the system unit.

3. Lower the SIMM into the socket, and ensure that

the SIMM is properly located in the connector.

4. Pushing gently on the top corners rotate the SIMM

towards the horizontal until it clips into place. Do not

use excessive force.

If the SIMM will not rotate easily remove it and start

again.

5. If the SIMM is properly located the SIMM should

remain in position held by the securing clips, and

with a small plastic lug through the holes on either

side of the SIMM.

Once you have installed all the SIMMs you can reassemble

the system.

Warning

When replacing the drive cradle, make sure that you keep

the cradle locating pins as far as possible into the cutouts

at the front of the drive cradle, while you swivel the cradle

back into place.