Installation guide

8
3. Using the handholds provided at the front and rear
of the drive cradle, lift the rear of cradle, swivelling it
about the two pegs at the front.
Warning
When removing the drive cradle ensure that you
support the front of the cradle, keeping the swivel
cutouts against the locating pegs. Failure to do so
may result in damage to SIMMs and the
motherboard.
4. With the cradle at approximately 30° move it
backwards to free it from the pegs and lift it clear.
5. Put the drive cradle down on a flat surface with the
handholds uppermost.
Warnings
1. Ensure that the drive cradle is stable.
2. The surface the drive cradle rests on must be
flat, any irregularity may come into contact with
the drives in the cradle and damage them.