User`s guide

Configuring the Security System
MASTER USER’S GUIDE 2/1
22 CONFIGURING THE SECONFIGURING THE SECURITYCURITY
SYSTEMSYSTEM
The security system is enabled and configured by using the LOC
Technology Setup utility. Once the security system is enabled,
individual users may be barred from accessing this utility.
For an Apricot computer with LOC Technology BIOS support,
BIOS reprogramming must be enabled in order to use the security
system. This feature is usually controlled by a jumper on the
motherboard (see the computer’s Owner’s Handbook for details). If the
Security Card is pre-installed at the factory, BIOS reprogramming
should be enabled by default. The security system itself will tell you
if you need to enable BIOS reprogramming.
Don’t forget to remove the SIN label from the Security Card and
record the SIN in a safe, secure place together with the serial
number of the card and the serial number of the computer in which
the card is installed.
Note
The Apricot LS Security Card is normally pre-installed at the factory. Refer to
Appendix A if you need to remove or re-install it.