Installation guide

5
Installing a memory module
An Apricot XEN-LS’s system memory can be extended to a
maximum of 8 Mbytes by fitting one memory module.
Modules with a variety of capacities are available. Your
choice of module depends on how much motherboard
memory you start with, which is different for different
XEN-LS models. The following table shows the total
amount of memory attainable using the various memory
modules.
Memory modules XEN-LS 386SX-16 XEN-LS 386SX-20 XEN-LS 486SX-20
available (1 Mbyte) (2 Mbytes) (4 Mbytes)
1 Mbyte module 2 Mbytes - 5 Mbytes
2 Mbyte module 3 Mbytes 4 Mbytes 6 Mbytes
4 Mbyte module 5 Mbytes 6 Mbytes 8 Mbytes
6 Mbyte module - 8 Mbytes -
8 Mbyte module 8 Mbytes 8 Mbytes 8 Mbytes
If your computer already has a memory module installed,
but has not reached the maximum capacity of 8 Mbytes,
you can remove the existing memory module and replace it
with one of a higher capacity. Note that, whenever you add
a module which would raise total memory above 8 Mbytes,
the memory in excess of 8 Mbytes is unusable.