User`s guide

SCSI drives
4/10 FT1200 HANDBOOK
Boot Device Configuration
Boot Channel
Specifies the SCSI channel from which the computer should boot.
The options are:
♦ A First (default) ♦ B First
Boot SCSI ID
Specifies the SCSI ID of the device from which you wish to boot.
The options are ID 0–15. The default is ID 0.
The SCSI ID selected here must correspond to the ID configured
on the boot device.
Boot LUN Number
Sets which LUN (Logical Unit Number) to boot from on your boot
device if your boot device has multiple LUNs and Multiple LUN
Support is enabled. The options are ID 0–7. The default is ID 0.
SCSI Device Configuration Menu
These settings enable you to configure each device on the SCSI bus.
You must know the SCSI ID of the device you want to configure.
Initiate Sync Negotiation
When Yes is selected, the motherboard initiates synchronous
negotiation with the SCSI device. When No is selected, the
motherboard does not initiate synchronous negotiation. If the SCSI
device initiates synchronous negotiation, the motherboard always
responds.
The options are:
♦ Yes (default) ♦ No
Maximum Sync Transfer Rate
Sets the maximum synchronous data transfer rate in MB/second.
The motherboard supports synchronous data transfer rates up to the
Ultra Fast SCSI maximum rate of 40 MB/second.
The options are:
♦ 40.0 (default) ♦ 32 ♦ 26.8 ♦ 20.0 ♦ 16.0 ♦ 13.4 ♦ 10.0