User`s guide

Safety and regulatory notices
IV
Important power switch information
The FT1200 power switch has dynamic control of the power supply
electronically. The power supply remains energised until the AC
supply is disconnected from the system by removal of its ‘disconnect
device’, i.e. the AC supply cord.
Do not open or remove system panels without:
♦
Taking suitable antistatic precautions.
♦
Disconnecting the supply cable from the rear of the system.
WarningWarning
The monitor power is not controlled by the system power switch, even if
the monitor power cord is connected to the system AC outlet. It must be
separately switched off or disconnected.
Power Cable Connections - UK ONLY
This equipment is supplied with an AC power cord that has a
moulded, non-removable, 3-pin AC plug.
Always replace the fuse with one of the same type and rating which
is BSI or ASTA approved to BS1362.
Always refit the fuse cover, never use the plug with the fuse cover
omitted.
Never substitute a power cord from any other appliance. If you
suspect a fault with the AC power lead, obtain a replacement from
your supplier or authorised maintainer.