Installation Guide

Connect your devices
network (WiFi). At times when you require a higher connection speed, we recommend
You can connect your devices via Data Cable (Ethernet) and also through wireless
connecting through the data cable. Remember that this must be Category 5e or higher.
Connection via wireless network (WiFi)
To be able to use the wireless connection, activate the WiFi of your device.
Then it searches the available WiFi networks. Select the one whose Name is on the label
below your modem and carefully enter the WiFi Key (composed of numbers and letters).
Connection by scanning the QR tag:
Quick connection via WPS
If your Smartphone or Tablet has a QR code reader, you can scan the code
labeled "WiFi". In this way you can quickly obtain the information of your
wireless WiFi network, and if your device allows it, it will automatically
connect you.
Note: This code is only valid to synchronize the parameters of the network with the factory
configuration of your Movistar Modem.
If your device supports WPS you can establish the WiFi connection using this method.
Make a short press (1 second is enough) of the WiFi / WPS button on the back of the
Medem. Then activate the WPS on your device within the next 2 minutes.
Congratulations, you can now navigate with your Movistar Optical Fiber!
Connection via cable Ethernet
Advanced configuration options
Restore to factory values
1 - Enter the router's Web portal, accessing with the browser the address associated to the
equipment http://192.168.1.1:8000. To access this website you must enter the password
that you will find in the label below your modem called "Modem access data"
1. With the modem on, press the reset button on the modem with a pen tip for at least 10
2. After approximately 90 seconds, your modem will have factory values again
seconds, and then release it.
(the Wifi and Password data will be the ones that appear on the labels)
Connect an Ethernet cable and turn on your device or computer. The Ethernet port light
will light green indicating that the connection is correct and will flash if there is activity.