User's Manual

Quick Start Guide

8 Wireless

Issue 02 (2014-04-29)

Figure 8-1 Network Setting > Wireless

8.2 Activate WPS

You can set up a wireless network with WPS (WiFi Protected Setup) or manually add a client

to your wireless network. Activating WPS helps you quickly set up a wireless network with

strong security.

Using the physical WPS button:

Step 1 Make sure the PWR/SYS LED is on (not blinking).

Step 2 Press the WIRELESS On/Off button for more than five seconds and release it. Press the

WPS button on another WPS-enabled device within range of the LTE Device. The WLAN/

WPS LED flashes while the LTE Device sets up a WPS connection with the wireless device.

----End

You must activate WPS in the LTE Device and in another wireless device within two minutes of each

other. See your User's Guide for more information.

Using the WPS button in the Web Configurator:

Step 1 Click Network Setting > Wireless > WPS, select Enable.

Step 2 Click the WPS button in the Method 1 PBC section and click Apply.