User's Manual

Chapter 7 Routing
B222s User’s Guide
77
7.2.1 Add/Edit Static Route
Click a dd ne w St a t ic Rout e in t he Rout ing screen or click the Edit icon next t o a rule. The
follow ing screen appears. Use t his screen t o configure the required inform at ion for a stat ic rout e.
Figure 42 Rout ing: Add/ Edit
The following t able describes t he labels in t his screen.
Table 24 Rout ing: Add/ Edit
LABEL DESCRIPTION
Act ive Click t his t o act ivat e this stat ic rout e.
Rout e Nam e Enter the nam e of the I P static rout e. Leave t his field blank t o delete this stat ic rout e.
Dest inat ion I P
Address
This param et er specifies the I P network address of t he final dest ination. Rout ing is always
based on netw ork num ber. I f you need t o specify a r oute t o a single host , use a subnet
m ask of 255.255.255.255 in t he subnet m ask field t o force the netw ork num ber t o be
ident ical t o t he host I D.
I P Subnet Mask Enter t he I P subnet m ask here.
Gateway I P
Address
You can decide if you want t o for ward packets t o a gateway I P address or a bound
interface.
I f you want t o configure Gat e w a y I P Addre ss, ent er the I P address of t he next- hop
gat eway. The gat eway is a rout er or switch on t he sam e netw ork segm ent as t he device's
LAN or WAN port. The gateway helps forward packet s t o their destinat ions.
Bound I nt erface You can decide if you want t o forwar d packets t o a gateway I P address or a bound
interface.
I f you want t o configure Bou nd I nt e r face, select the check box and choose an int erface
through w hich t he t raffic is sent.
Apply Click Apply t o save your changes.
Back Click Back to exit this screen wit hout saving.