User's Manual

Chapter 7 Routing
B222s User’s Guide
76
7.2 Configuring Static Route
Use t his screen t o view and configure I P stat ic rout es on the LTE Device. Click N et w or k Set t ing >
St a tic Rout e to open t he following screen.
Figure 41 Net work Set ting > St at ic Route
The following t able describes t he labels in t his screen.
Table 23 Network Sett ing > St atic Rout e
LABEL DESCRIPTION
Add New Stat ic
Rout e
Click t his t o set up a new st atic rout e on the LTE Device.
# This is t he num ber of an individual stat ic rout e.
Act ive This indicat es whether t he rule is act ive or not.
A yellow bulb signifies t hat this stat ic rout e is act ive. A gray bulb signifies that t his stat ic
rout e is not act ive.
St atus This shows w het her the stat ic rout e is curr ently in use or not . A yellow bulb signifies t hat
this stat ic rout e is in use. A gray bulb signifies t hat t his stat ic rout e is not in use.
Nam e This is t he nam e t hat describes or identifies t his route.
Dest inat ion I P This param et er specifies the I P netw ork address of t he final dest ination. Rout ing is always
based on network num ber.
Gateway This is t he I P address of t he gat eway. The gat eway is a router or swit ch on t he sam e
net work segm ent as the device's LAN or WAN por t. The gateway helps forward packet s t o
their dest inat ions.
Subnet Mask This param et er specifies the I P network subnet m ask of the final dest ination.
I nt erface This indicat es which interface handles t he t raffic forwarded by this route.
Modify Click t he Edit icon to go t o t he screen where you can set up a st at ic rout e on t he LTE
Device.
Click t he De le t e icon t o r em ove a st at ic rout e from t he LTE Device.