User's Manual

Chapter 5 Wireless
B222s User’s Guide
63
on the first device, it present s it s PI N t o t he second device. I f the PI N m atches, one device sends
the network and security inform ation t o t he ot her, allowing it t o j oin the network.
Take t he following st eps t o set up a WPS connection bet ween an access point or wireless rout er
( referred t o here as t he AP) and a client device using the PI N m ethod.
1 Ensure WPS is enabled on bot h devices.
2 Access t he WPS section of t he AP’s configurat ion int erface. See t he device’s User’s Guide for how to
do this.
3 Look for t he client ’s WPS PI N; it will be displayed either on the device, or in t he WPS sect ion of the
client ’s configuration interface ( see the device’s User’s Guide for how t o find t he WPS PI N - for the
LTE Device, see
Section 5.4 on page 53) .
4 Enter t he client ’s PI N in the AP’s configurat ion interface.
5 I f t he client device’s configurat ion interface has an area for ent ering anot her device’s PI N, you can
eit her enter t he client ’s PI N in t he AP, or enter t he AP’s PI N in the client - it does not m att er which.
6 St art WPS on bot h devices wit hin t wo m inut es.
7 Use t he configurat ion utility t o activat e WPS, not the push-butt on on t he device it self.
8 On a com puter connect ed t o t he wireless client , t ry t o connect t o t he I nt ernet . I f you can connect,
WPS was successful.
I f you cannot connect , check the list of associat ed wireless client s in the AP’s configuration utility. I f
you see t he wireless client in t he list , WPS was successful.