User's Manual

Chapter 5 Wireless

B222s User’s Guide

Click N e t w or k Set ting > W ire less t o open t he Genera l screen. Select t he En a ble W ir e less LAN

checkbox t o show t he Wir eless configurations.

Figure 20 Net work Set ting > Wireless > General

The following t able describes t he labels in t his screen.

Table 7 Network > Wireless LAN > General

LABEL DESCRIPTION

Wireless Net work Set up

Wireless Select t he Ena ble W ireless LAN check box to activat e t he wir eless LAN.

Wireless Net work Sett ings

Wireless

Net work Nam e

( SSI D)

The SSI D ( Service Set I Dentit y) ident ifies the ser vice set w ith which a wireless

device is associated. Wireless devices associat ing t o t he access point ( AP) m ust

have the sam e SSI D.

Enter a descript ive nam e ( up to 32 English keyboard charact ers) for the wireless

LAN.

Hide SSI D Select this check box t o hide t he SSI D in t he out going beacon fram e so a st at ion

cannot obt ain t he SSI D t hrough scanning using a site survey t ool.

BSSI D This show s t he MAC address of t he w ireless int erface on t he LTE Device when

wireless LAN is enabled.

Mode Select This m akes sure t hat only com pliant WLAN devices can associat e wit h t he LTE

Device.

Select 8 0 2 .1 1 b/ g/ n to allow I EEE802.11b, I EEE802.11g and I EEE802.11n

com pliant WLAN dev ices t o associat e wit h the LTE Device. The transm ission rat e of

your LTE Device m ight be r educed.

Select 8 0 2 .1 1 b/ g to allow bot h I EEE802.11b and I EEE802.11g com pliant WLAN

devices t o associate with the LTE Device. The t ransm ission rate of your LTE Device

m ight be reduced.

Select 8 0 2 .1 1 g On ly to allow only I EEE 802.11g com pliant WLAN devices t o

associat e wit h the LTE Device. Select 8 0 2 .1 1 n only in 2 .4 G band to allow only

I EEE 802.11n com pliant WLAN devices wit h the sam e frequency range ( 2.4 GHz) t o

associat e wit h the LTE Device.