User's Manual Part 1

Chapter 7 Network Setting
BM2022w User’s Guide
100
7.3 PPPoE
Use these settings to configure the PPPoE connection between the WiMAX Device and the service
provider.
Click Network Setting > WAN > PPPoE.
Figure 46 PPPoE Screen
WAN IP Request
Timeout
Enter the number of seconds the BM2022w waits for an IP from the ISP before it
times out.
WAN IP Address If the BM2022w gets its IP from the user, enter the IP address it is to use.
WAN IP Subnet
Mask
If the BM2022w gets its IP from the ISP, enter the IP address it is to use.
Gateway IP
Address
If the BM2022w gets its gateway IP address from the user, enter the IP address
it is to use.
MTU Enter the Maximum Transmission Unit (MTU) for the BM2022w. This is the
largest protocol unit that the BM2022w allows to pass through it.
Clone MAC
Address
Enter a MAC address here for registering bridged devices on the network if their
current MAC addresses are causing problems. For example, this can happen
when a desktop computer swaps network interface cards; the original NIC may
have used its MAC address to register itself on the network and now the new NIC
is unrecognized. Using a MAC address that you know is valid, i.e. a “clone”,
allows that device to stay registered.
First~Third DNS
Server
Select how the BM2022w acquires its DNS server address.
• From ISP - Select this to have the BM2022w acquire its DNS server address
from the ISP.
• User Define - Select this to manually enter the DNS server used by the
BM2022w.
Table 28 WAN (continued)
LABEL DESCRIPTION