User's Manual Part 1

Chapter 6 WiMAX
BM2022w User’s Guide
73
Click WiMAX > Profile > Connection Settings to open this screen as shown next.
Figure 27 Connection Settings Screen
This screen contains the following fields:
Table 13 Connection Settings
LABEL DESCRIPTION
Connection Option Settings
Auto
Reconnect
Select the interval in seconds that the BM2022w waits after getting disconnected
from the base station before attempting to reconnect.
Auto Connect
Mode
Select the auto connect mode.
• By channel power - Auto connects to the base station if the signal strength
of the channel is sufficient for the BM2022w.
• By CINR - Auto connects to the base station if the signal-to-noise ratio is
sufficient for the BM2022w.
Enable
Handover
Select this to maintain connectivity while the BM2022w switches its connection
from one base station to another base station.
Enable MS
Initiated Idle
Mode
Select this to have the BM2022w enter the idle mode after it has no traffic
passing through for a pre-defined period. Make sure your base station also
supports this before selecting this.
Idle Mode
Interval
Set the idle duration in minutes. This is how long the BM2022w waits during
periods of no activity before going into idle mode.
CINR & RSSI
Refresh
Interval
Set the refresh interval in milliseconds for calculating the signal-to-noise
measurement (CINR) and signal strength measurement (RSSI) of the BM2022w.
LDRP (Low
Data Rate
Protection)
Enter the Low Data Rate Protection (LDRP) time in milliseconds. If the uplink/
downlink data rate is smaller than the LDRP time, the BM2022w sends a
disconnect request to the base station.
LDRP TX Rate Enter the outgoing data rates for LDRP in bytes per second.
LDRP RX Rate Enter the incoming data rates for LDRP in bytes per second.
Connection Type Settings