User's Manual Part 1

Chapter 7 Network Setting
BM2022w User’s Guide
116
Note: The configuration you set in this screen takes priority than the Network Setting >
NAT > Port Forwarding screen.
Figure 62 DMZ Screen
This screen contains the following fields:
7.17 ALG
Use these settings to bypass NAT on your WiMAX Device for those applications that are "NAT un-
friendly".
Click Network Setting > NAT > ALG to open this screen as shown next.
Figure 63 ALG Screen
This screen contains the following fields:
Table 44 DMZ
LABEL DESCRIPTION
DMZ Enable Click this check box to enable DMZ.
DMZ Host Enter the IP address of your network DMZ host, if you have one. 0.0.0.0 means
this feature is disabled.
Table 45 Network Setting > NAT > ALG
LABEL DESCRIPTION
Enable FTP ALG Turns on the FTP ALG to detect FTP (File Transfer Program) traffic and helps build
FTP sessions through the BM2022w’s NAT.
Enable H.323 ALG Turns on the H.323 ALG to detect H.323 traffic (used for audio communications)
and helps build H.323 sessions through the BM2022w’s NAT.
Enable IPsec ALG Turns on the IPsec ALG to detect IPsec traffic and helps build IPsec sessions
through the BM2022w’s NAT.
Enable L2TP ALG Turns on the L2TP ALG to detect L2TP traffic and helps build L2TP sessions
through the BM2022w’s NAT.
Enable PPTP ALG Turns on the PPTP ALG to detect PPTP traffic and helps build PPTP sessions
through the BM2022w’s NAT.