User's Manual Part 1

Chapter 7 Network Setting
BM2022w User’s Guide
107
This screen contains the following fields:
7.10 MAC Address Filter
Use these screens to configure a MAC (Media Access Control) address filter to restrict access to the
network.
Click on Network Setting > WLAN > MAC Address Filter. The screen appears as shown.
Figure 53 MAC Address Filter Screen
This screen contains the following fields:
Table 35 WPS
LABEL DESCRIPTION
Enable WPS Select Enable and click Apply to activate WPS on the BM2022w. Select Disable
and click Apply to deactivate WPS.
Start WPS PBC This field is available after you select Enable in the Enable WPS field and click
Apply.
Click this to activate the Push Button Configuration. After clicking this you will be
able to use the WPS button at the back of the device to add new wireless clients.
Note: You must press the WPS buttons within two minutes of each other.
Table 36 MAC Address Filter
LABEL DESCRIPTION
Enable MAC
Address Filter
Select the check box to enable MAC address filtering. Then, the following fields
display.
Mode
Define the filter action for the list of MAC addresses in the MAC address
table.
Select Allow listed stations to permit access to the BM2022w only to
addresses listed. MAC addresses not listed will be denied access to the
BM2022w.
Select Deny listed stations to block access to the BM2022w to the
computers or devices listed in this list.
# This is the index number of the MAC address.
Active Select this box to make the policy effective or ineffective for a particular device.