User's Manual Part 1

Chapter 7 Network Setting
BM2022w User’s Guide
103
7.7 DHCP
Use these settings to configure whether the WiMAX Device functions as a DHCP server for your local
network, or a DHCP relay between the local network and the service provider. You can also disable
the DHCP functions.
Click Network Setting > LAN > DHCP to open this screen as shown next.
Figure 50 DHCP Screen
This screen contains the following fields:
Table 33 DHCP
LABEL DESCRIPTION
DHCP Server
DHCP Mode Select this if you want the BM2022w to be the DHCP server on the LAN. As a
DHCP server, the BM2022w assigns IP addresses to DHCP clients on the LAN and
provides the subnet mask and DNS server information.
• None - This disables DHCP mode for the BM2022w.
• Server - This sets the BM2022w as a DHCP server for the LAN.
• Relay - This sets the BM2022w as a DHCP relay for the LAN, allowing it to
pass-through IP addresses assigned to LAN devices from the ISP servers.
Start IP Enter the start IP address from which the BM2022w begins allocating IP
addresses.
End IP Enter the end IP address at which the BM2022w ceases allocating IP addresses.