User's Manual

Chapter 7 Network Setting
BM2022 Users Guide
99
7.7 DHCP
Use these settings to configure whether the WiMAX Device functions as a DHCP server for your local
network, or a DHCP relay between the local network and the service provider. You can also disable
the DHCP functions.
Click Network Setting > LAN > DHCP to open this screen as shown next.
Figure 41 DHCP Screen
This screen contains the following fields:
Table 30 DHCP
LABEL DESCRIPTION
DHCP Server
DHCP Mode Select this if you want the BM2022 to be the DHCP server on the LAN. As a DHCP
server, the BM2022 assigns IP addresses to DHCP clients on the LAN and
provides the subnet mask and DNS server information.
 None - This disables DHCP mode for the BM2022.
 Server - This sets the BM2022 as a DHCP server for the LAN.
 Relay - This sets the BM2022 as a DHCP relay for the LAN, allowing it to
pass-through IP addresses assigned to LAN devices from the ISP servers.
Start IP Enter the start IP address from which the BM2022 begins allocating IP
addresses.
End IP Enter the end IP address at which the BM2022 ceases allocating IP addresses.