User's Manual

Chapter 6 WiMAX
BM2022 Users Guide
79
This screen contains the following fields:
6.7 RAPL Settings
This screen allows you to specify the Roaming Agreement Preference List (RAPL) of preferred NSPs
for establishing connections to the Home NSP. The RAPL is a list of NSPs that are affiliated with the
Home NSP through roaming agreements. A NSP specified in the RAPL is a V-NSP and can route
data to the Home NSP.
Click WiMAX > ND&S > RAPL Settings to open this screen as shown next.
Figure 27 RAPL Settings
Table 16 CAPL Settings: Add
LABEL DESCRIPTION
NAP ID Specify the NAP ID in the format XX:XX:XX where X is a hexadecimal character.
The NAP ID is typically the first three blocks of the BSID of the base station.
Priority Specify the priority for the NAP ID. Enter 1-250 where 1 is the highest priority.
The BM2022 will search for NAPs according to the priority specified.
Priority may be determined by the number of base stations an NAP has, with a
NAP having more base stations being assigned a higher priority. If the same
priority is assigned to a NAP ID, the BM2022 will consider them as having equal
priority.
Select Channel Plan ID
Select After clicking a Channel Plan ID entry in the list, you can click this check box to
select it.
Start
Frequency
(KHz)
This indicates the beginning of a frequency band in kilohertz (KHz).
End
Frequency
(KHz)
This indicates the end of the frequency band in kilohertz (KHz).
Step (KHz) This indicates the frequency step within each band in kilohertz (KHz).
Bandwidth
(MHz)
This indicates the bandwidth in megahertz (MHz).
OK Click this button to save any changes made to the list.
Save Click this to save the changes made.
Cancel Click this avoid any changes made from being saved to your configuration.