User's Manual

Chapter 6 WiMAX
BM2022 Users Guide
71
Click WiMAX > Profile > Frequency Settings to open this screen as shown next.
Figure 20 Frequency Settings Screen (By List)
Figure 21 Frequency Settings Screen (By Range)
This screen contains the following fields:
Table 12 Frequency Settings
LABEL DESCRIPTION
Setting Type Select whether to scan base stations by entering specific frequency(-ies) (By
List) or a range of frequencies (By Range).
Note: When you select By Range, you can only configure one range of
frequencies in this screen. To configure multiple frequency ranges, use the
WiMAX > Wide Scan screen.
Note: Some settings in this screen are only available depending on the Setting
Type selected.
Join Wide Scan
Result
The scanning result of the frequency to scan you configured in this screen will
be shown in the WiMAX > Connect screen. Select this option to determine
whether to also append the wide scanning result (configured in the WiMAX >
Wide Scan screen) to the same table.
Default
Bandwidth
Select the default bandwidth (size) per frequency band you specify in table A.
A (When By List is selected in the Setting Type field)
Frequency
(KHz)
This displays the center frequency of an frequency band in kilohertz (KHz).
Click the number to modify it.
Enter the center frequency in this field when you are adding an entry.
Bandwidth
(MHz)
This displays the bandwidth of the frequency band in megahertz (MHz). If you
set a center frequency to 2600000 KHz with the bandwidth of 10 MHz, then the
frequency band is from 2595000 to 2605000 KHz.
Click the number to modify it.
Enter the bandwidth of the frequency band in this field when you are adding an
entry.
A
B
A
B