User's Manual

SETUP & USER GUIDE DWA0100

DWA0100-20170224-0000v0.0

This document contains Technicolor proprietary and confidential information. Passing on and copying of this document, use,

extraction and communication of its contents, is not permitted without written authorization from Technicolor.

2.2 Connect Wired Devices

When setting up the Wireless Gateway for the first time, connect the host computer via Ethernet

connection.

1 Connect one end of the RJ-45 cable to one of the Ethernet (1, 2, 3, 4) ports of your Wireless Gateway.

2 Connect the other end of the RJ-45 cable to the Ethernet port of the computer.

3 Repeat the above steps to connect other computers to the Wireless Gateway via Ethernet connection.

4 To connect more than four computers, use a hub or switch. Connect one end of an RJ-45 cable to the

hub or switch and the other end to the computer.

2.3 Connect Wireless Devices

Before connecting wireless devices to the Wireless Gateway, configure the wireless security settings of

your Wireless Gateway (see “To Set up Security Settings on page 46”). Take note of the SSID and the

password you have set, you need the SSID and the password to connect devices to your Wireless

Gateway.

2.3.1 WLAN

From the wireless device end, search for the Wireless Gateway network name (SSID), and enter the

passphrase to connect.

The SSID and passphrase are the ones you have set in the Wireless Security Settings (see “To Set up

Security Settings on page 46”).

2.3.2 Wi-Fi Protected Setup (WPS)

Press and hold the WPS button of the Wireless Gateway for at least 8 seconds and press the WPS

button on the WPS-enabled device to start pairing.

2.4 Connect the Broadband (DSL)

1 Connect one end of the RJ-11 cable to the DSL port of your Wireless Gateway.

2 Connect the other end of the RJ-11 cable to a wall jack with DSL service.