User's Manual

Customer Information FCC Part 68
Customer information required for Telephone Terminal Equipment (“TTE”)
approved for connection to the Public Switched Telephone Network
(“PSTN”), pursuant to 47 CFR §68.218(b)(1)e
FCC Part 68 Compliancy for equipment TG788v v3
This equipment complies with Part 68 of the FCC rules and the requirements adopted by the ACTA. On the
bottom of this equipment is a label that contains, among other information, a product identifier in the format
US:AAAEQ##TXXXX. If requested, this number must be provided to the telephone company.
Based upon the information on the grant US: TMBDL01ATG788VV3HP, this equipment TG788v v3 uses
Certification jack Universal Service Order Code (“USOC”): RJ-11C.
A plug and jack used to connect this equipment to the premises wiring and telephone network must comply
with the applicable FCC Part 68 rules and the requirements adopted by the ACTA. A compliant telephone
cord and a modular plug is provided with this product. It is designed to be connected to a compatible
modular jack that is also compliant. See installation instructions for details.
The REN is used to determine the number of devices that may be connected to a telephone line.
Excessive RENs on a telephone line may result in the devices not ringing in response to an incoming call.
In most but not all areas, the sum of the RENs should not exceed five (5.0). To be certain of the number of
the devices that may be connected to a line, as determined by the total RENs, contact the local telephone
company. For products approved after July 23, 2001, the REN for this product is part of the product
identifier that has the format US:AAAEQ##TXXXX. The digits represented by ## are the REN without a
decimal point (e.g., 01 is a REN of 0.1). For earlier products, the REN is separately shown on the label.
If this equipment
DWA0100 causes harm to the telephone network, the telephone company will notify you
in advance that the temporary discontinuance of service may be required. But if advance notice isn’t
practical, the telephone company will notify the customer as soon as possible. Also, you will be advised of
your right to file complaint with the FCC if you believe it is necessary.
The telephone company may make changes in its facilities, equipment, operations or procedures that
could affect the operation of the equipment. If this happens, the telephone company will provide advance
notice in order to make necessary modifications to maintain uninterrupted service.
If trouble is experienced with this equipment
DWA0100, for repair or warra
nty information, please contact:
Techni
color, 101W. 103rd St., Indianapolis, IN 46290 USA, Phone: [phone].
If the equipment is causing harm to the telephone network, the telephone company may request that you
disconnect the equipment until the problem is resolved.
The equipment DWA0100 is not intended to be rep
aired by the customer.
Connection to party lines servi
ce is
subject to state tariffs. Contact the state public utility commission,
public service commission or corporation commission for the information.
If your home has specially wired alarm equipment connected to the telephone line, ensure that the
installation of this equipment
DWA0100 does not disable your alarm equipment. If you have questions
about what will disable alarm equipment, consult your telephone company or qualified installer.
Electrical Safety Advisory
As Electrical surges, typically lightning transients, are very destructive to customer terminal equipment that
is powered by AC power sources, the customer is advised to provide a surge arrestor on the AC mains
supply.
DMS3-SAF-25-468 v1.0
Copyright © 2017 Technicolor. All rights reserved.
DWA0100
MSCDL01ADWA0100
DWA0100