User's Manual

45
SETUP & USER GUIDE DWA0100
DWA0100-20170224-0000v0.0
Copyright © 2017 Technicolor. All rights reserved.
This document contains Technicolor proprietary and confidential information. Passing on and copying of this document, use,
extraction and communication of its contents, is not permitted without written authorization from Technicolor.
To Configure the Wireless Network
1 Click Configure on the upper-right corner of the screen.
2 Enter or take note of the following information:
 Interface Enabled — Check to enable the wireless access point.
 Physical Address — Displays the MAC address of the wireless device.
 Network Name (SSID) — Enter desired wireless network name. This is the name shown to other
wireless devices to connect to your network.
 Actual Speed — Displays the network speed
 Band — Displays the channel band.
 Channel Selection — Select the automatic or manual channel selection.
 Region — Displays your current region.
 Channel — If Channel Selection is set to manual, select the channel from the list.
3 If necessary, configure the security settings; see "To Set up Security Settings" on page 46.
4 Click Apply to save changes.