User's Manual

33
SETUP & USER GUIDE DWA0100
DWA0100-20170224-0000v0.0
Copyright © 2017 Technicolor. All rights reserved.
This document contains Technicolor proprietary and confidential information. Passing on and copying of this document, use,
extraction and communication of its contents, is not permitted without written authorization from Technicolor.
3 Enter the name for the new firewall security level.
4 Select a security level.
5 Click Apply to save changes.
7.4.3 Set Filter Rules
After you create a new security level, you can set firewall rules.
1 On the Firewall page, click Configure on the upper-right corner of the screen.
2 Click Edit. The Firewall Settings appears.
3 On the Firewall Settings table, click Add.
4 Enter the necessary parameters:
 Name — Enter desired firewall rule name
 Enabled — Check this box to enable this firewall rule.
 Source Interface — Select the interface to apply the firewall rule.
 Source Address — Select the firewall source address.
 User-Defined — If the address is not listed in the Source Address box, enter a user-defined address
here.
 Destination Interface — Select the destination interface.