User's Manual

SETUP & USER GUIDE DWA0100

DWA0100-20170224-0000v0.0

This document contains Technicolor proprietary and confidential information. Passing on and copying of this document, use,

extraction and communication of its contents, is not permitted without written authorization from Technicolor.

2.4.1 Use a Splitter

You need a splitter when connecting the Wireless Gateway to the wall jack that also connects to a

telephone.

1 Plug the splitter to the wall jack with DSL service.

2 Connect one end of the RJ-11 cable to the DSL port of your Wireless Gateway.

3 Connect the other end of the RJ-11 cable to the splitter.

4 Connect the telephone to the splitter using another RJ-11 cable.

2.5 Check the Installation

To ensure that all devices are properly connected, check the LED indicators on the front of your Wireless

Gateway. For basic installation, the following LEDs must be lit:

▪ Power LED

▪ Ethernet LED

▪ DSL LED

The lighted LED indicators vary depending on the type of connection that you make. See “Front Panel” on

page 5 for more information about the LED indicators.