User's Manual

Chapter 9 Network Address Translation (NAT) 75
9.2.2 The Port Forwarding Add/Edit Screen
This screen lets you create or edit a port forwarding rule. Click Add new rule in the Port
Forwarding screen or the Edit icon next to an existing rule.
Figure 52 NA
T > Port Forwarding: Add/Edit
Internal Port This is the internal port number that identifies a service.
Client IP This is the IP address of the device for which the Router created the UPnP rule.
Protocol This is the protocol of the traffic for which the Router created the UPnP rule.
Table 43 Network Setting > NAT > Port Forwarding (continued)
LABEL DESCRIPTION
Table 44 NAT > Port Forwarding: Add/Edit
LABEL DESCRIPTION
Active Select or clear this field to turn the port forwar
ding rule on or off.
Service Name Select a service to forward or select User Defined and ent
er a name in the field to the
right.
External Start
Po
rt
Configure this for a user-defined entry. Enter the original destination port for the
packets.
To forward only one port, enter the port number again in the External End Port f
ield.
To forward a series of ports, enter the start port number here and the end port number
in t
he External End Port field.