User's Manual
Table Of Contents
- HGW-2501GN-R2 User’s Guide
- Contents
- Introduction
- Introducing the Web Configurator
- WAN
- Wireless 2.4GHz
- LAN
- Static Route
- Quality of Service (QoS)
- Network Address Translation (NAT)
- Dynamic DNS
- Filter
- Firewall
- Parental Control
- Certificates
- VoIP
- System Monitor
- User Account
- System
- Time Setting
- Log Setting
- Firmware Upgrade
- Backup/Restore
- Remote Management
- Troubleshooting
- Safety Warnings
- New Bookmark
Chapter 1 Introduction 9
1.3 LEDs (Lights)
The following graphic displays the labels of the LEDs.
Figure 3 Front Panel LEDs
Table 2 LED Descriptions
LED COLOR STATUS DESCRIPTION
POWER Green On The Router is receiving power and ready for use.
Red On The Router has hardware failure.
Blinking The Router detected an error while self-testing.
Off The Router is not receiving power.
LAN1-4 Green On The Router has a successful Ethernet connection with a device on
the LAN.
Blinking The Router is sending or receiving data to/from the LAN.
Off The Router does not have an Ethernet connection with the LAN.
WPS/WLAN Green On The wireless network is activated.
Blinking The Router is communicating with other wireless clients.
Off The wireless network is not activated.
Yellow Blinking The Router is setting up a WPS connection.
DSL Green On The Router is connected and synchronized with the central system.
Slow Blinking The Router is detecting a VDSL line.
Fast Blinking The Router is negotiating VDSL line parameters.
Off The Router is off line or not connected to the central system.