User's Manual

Chapter 10 Filter 76
Table 44 Security > Filter > IP/MAC Filter
LABEL DESCRIPTION
Rule Type selection Select White List to create a filter rule that allows traffic.
Select Black List to create a filter rule that blocks traffic.
IP/MAC Filter Rule Index Select the index number of the filter rule.
Active Use this field to enable or disable the rule.
Interface Select the interface to which to apply the filter.
Direction Apply the filter to In
coming or Outgoing traffic direction.
Rule Type Select IP to filter traffic by IP addresses.
Select MAC to filter traffic by MAC address.
Source IP Address Enter the source IP address of the packets you wish to filter.
Subnet Mask Enter the IP subnet mask for the source IP address
Port Number Enter the source port of the packets that you wish to filter.
Destination IP Address Enter the destination IP address of the packets you wish to filter.
Subnet Mask Enter the IP subnet mask for the destination IP address.
Port Number Enter the destination port of the packets that you wish to filter.
Protocol Select IC
MP, TCP or UDP for the upper layer protocol.
Source MAC Address This field is only available when you select MAC in the Rule Type field.
Enter the MAC address of the packets you wish to filter.
Active This field shows whether the rule is activated.
Interface This field shows the interface to which the filter rule applies.
Direction The filter rule applies to this traffic direction.
Src IP/Mask This is the source IP address and subnet mask when you select IP as
the rule
type.
This is the MAC address when you select MAC as the rule type.
Dest IP/Mask This is the destination IP address and subnet mask.
MAC Address For a MAC filter rule this field shows the MAC address of the packets to filter.
Src Port This is the source port number.
Dest Port This is the destination port number.
Protocol This is the upper layer protocol.