User's Manual

Chapter 8 Network Address Translation (NAT) 69
8.3 The Address Mapping Screen
Ordering your rules is important because the Router applies the rules in the order that you specify.
When a rule matches the current packet, the Router takes the corresponding action and the
remaining rules are ignored.
This screen is available only when you select NAT Full Feature on in the General screen. To change
your Router’s address mapping settings, click Network Setting > NAT > Address Mapping.
Network Setting > NAT > Address Mapping
External End Port Configure this for a user-defined entry. Enter the last port of the original destination
port range.
To forward only one port, enter the port number in the External Start Port field above
and then enter it again in this field.
To forward a series of ports, enter the last port
number in a series that begins with the
port number in the External Start Port field above.
Server IP Address Enter the inside IP address of the virtual server here.
Protocol Select the protocol supported by this virtual server. Choices are TCP, UDP, or TCP/UDP.
Open Start Port Configure this for a user-defined entry. This shows the port number to which you want
the Router to translate the incoming port. For a range of ports, enter the first number
of the range to which you want the incoming ports translated.
Open End Port Configure this for a user-defined entry. This shows the last port of the translated port
range.
Table 39 NAT > Port Forwarding: Add/Edit (continued)
LABEL DESCRIPTION
Table 40 Network > NAT > Address Mapping
LABEL DESCRIPTION
Add new rule Click this to add a new address mapping rule.
Mapping Set This is the index number of the address mapping set.
Local Start IP This is the starting Inside L
ocal IP Address (ILA).
Local End IP This is the end Inside Local IP Address (ILA).
Global Start IP This is the starting Inside Global IP Address (IGA).
Global End IP This is the ending Inside Global IP Address (IGA).