User's Manual
Table Of Contents
- HGW-2501GN-R2 User’s Guide
- Contents
- Introduction
- Introducing the Web Configurator
- WAN
- Wireless 2.4GHz
- LAN
- Static Route
- Quality of Service (QoS)
- Network Address Translation (NAT)
- Dynamic DNS
- Filter
- Firewall
- Parental Control
- Certificates
- VoIP
- System Monitor
- User Account
- System
- Time Setting
- Log Setting
- Firmware Upgrade
- Backup/Restore
- Remote Management
- Troubleshooting
- Safety Warnings
- New Bookmark
Chapter 4 Wireless 2.4GHz 30
4.1.1 No Security
Set the Security Mode to OPEN to allow wireless stations to communicate with the Router without
any data encryption or authentication.
If you do not enable any wireless security on your Router, your network is accessible to any
wireless networking device that is within range.
Figure 14 Wireless 2.4GHz > General: OPEN
Operating
Channel
This is the channel currently being used by your AP.
Security Mode Select WEP or WPA2-PSK or WPA/WPA2 PSK mixed to add security on this wireless
network. The wireless clients which want to associate to this network must have the
same wireless security settings as the Router. When you select to use a type of wireless
security, additional options appears in this screen.
If you select OPEN, the Router allows any client to associate with this network without
any data encryption or authentication.
Table 6 Network Setting > Wireless 2.4GHz > General (continued)
LABEL DESCRIPTION