User's Manual

Chapter 3 WAN 27
RIP Version This field is not configurable if you select None in the RIP Direction field.
Select the RIP version from RIP-1 and
RIP2-B/RIP2-M.
Multicast The Router supports IGM
P-v1, IGMP-v2 and IGMP-v3. Select None to disable it.
MLD Proxy Select MLD v1 or MLD v2 to have the Ro
uter act as an MLD proxy on this connection. This
allows the Router to get subscription information and maintain a joined member list for each
multicast group. It can reduce multicast traffic significantly.
Select None
to disable this featur
e.
PPPoE
Pass
through
his field is available when you select PPPoE encapsulation.
In addition to the Router’s built-in PPPoE client, you can select Yes to enable PPP
oE pass
through to allow up to ten hosts on the LAN to use PPPoE client software on their computers
to connect to the ISP via the Router. Each host can have a separate account and a public WAN
IP address. PPPoE pass through is an alternative to NAT for application where NAT is not
appropriate.
Select No t
o
disable PPPoE pass through if you do not need to allow hosts on the LAN to use
PPPoE client software on their computers to connect to the ISP.
MTU
MTU Enter the MTU for this WAN interface in this field.
MRU
MRU Enter the MRU (Maximum Receive Unit) for this WAN interface.
Table 5 Network Setting > WAN: VDSL: Edit (continued)
LABEL DESCRIPTION