User's Manual
Table Of Contents
- HGW-2501GN-R2 User’s Guide
- Contents
- Introduction
- Introducing the Web Configurator
- WAN
- Wireless 2.4GHz
- LAN
- Static Route
- Quality of Service (QoS)
- Network Address Translation (NAT)
- Dynamic DNS
- Filter
- Firewall
- Parental Control
- Certificates
- VoIP
- System Monitor
- User Account
- System
- Time Setting
- Log Setting
- Firmware Upgrade
- Backup/Restore
- Remote Management
- Troubleshooting
- Safety Warnings
- New Bookmark
Chapter 3 WAN 23
PPPoE
Passthrough
his field is available when you select PPPoE encapsulation.
In addition to the Router’s built-in PPPoE client, you can select Yes to enable PPP
oE pass
through to allow up to ten hosts on the LAN to use PPPoE client software on their computers
to connect to the ISP via the Router. Each host can have a separate account and a public WAN
IP address. PPPoE pass through is an alternative to NAT for application where NAT is not
appropriate.
Select No t
o disable PPPoE pass through if you do not need to allow hosts on the LAN to use
PPPoE client software on their computers to connect to the ISP.
MTU
MTU Enter the MTU (Maximum Transmission Unit)
for this W
AN interface.
MRU
MRU Enter the MRU (Maximum Receive Unit) for this WAN interface.
Table 4 Network Setting > WAN: ADSL: Edit (continued)
LABEL DESCRIPTION