User's Manual

Chapter 3 WAN 21
PPP
Authentication
Select an authentication protocol for outgoing calls:
AUTO - Your Router accepts either CHAP or PAP when requested by this remote node.
CH
AP - Your Router accepts CHAP only.
PA
P - Your Router accepts PAP only.
VPI The valid
range for the VPI is 0 to 255. Enter the VPI
assigned to you.
VCI The valid range for the VCI is 32 to 65535 (0 to 31
is reserved for local management of ATM
traffic). Enter the VCI assigned to you.
IP Address
Obtain an IP
Ad
dr
ess
Automatically
Select this option to use a dynamic IP address.
Static IP Address Select this option if the ISP gave them a specific IP
address to use.
IP Address This option is available if you select Router in the Mode field
and IPv4 or IPv4/IPv6 in the
IPv6/IPv4 Dual Stack field.
Enter the IP address your ISP has assigned.
DNS Server
Dynamic Select this option to use a dynamic DNS server.
Static Select this option if the ISP gave them a specific DNS ser
ver to use.
Primary DNS Enter the primary DNS server’s address for the Router.
Secondary DNS Enter the secondary DNS server’s address for the Router.
IPv6 Address
Obtain an IP
Ad
dr
ess
Automatically
Select this option to obtain an IPv6 address automatically.
DHCP IPv6 Select DHCP to obtain an IPv6 address from a DHCPv6 server. Select SLAAC to have the
Router use the prefix to automatically generate a unique IP address that does not need to be
maintained by a DHCP server.
DHCP PD Select Enable to use DHCP PD (Pr
efix Delegation) to allow the Router to pass the IPv6 prefix
information to its LAN hosts. The hosts can then use the prefix to generate their IPv6
addresses.
Static IPv6
Address
If you select Static IPv6 Address, enter the IPv6 address and the address prefix length that
the Router uses.
IPv6 Address Enter the IPv6 address assigned by your ISP.
Prefix length Enter the address prefix length to specify how many most significant b
its in an IPv6 address
compose the network address.
Table 4 Network Setting > WAN: ADSL: Edit (continued)
LABEL DESCRIPTION