Operator`s manual

HT60D / HT70S Hedgetrimmer
14
Original Instructions Version Mar12
Stopping the Engine
Set the engine to idling by releasing the throttle lever.
Set the ignition switch to the o position ‘’O’’ (STOP).
If the engine fails to stop, set the choke lever to the closed position to stall the engine; do not use the
machine until the ignition switch is repaired.
Running In
During the rst ten hours of work, avoid running the engine at maximum speed for a prolonged period until
all the components have bedded in, after the engine has been run in, it will reach its maximum power.
IMPORTANT
After every use, check that all nuts bolts and screws are securely fastened and tighten if necessary.
Rear handle (HT60D)
To reduce fatigue when trimming hedges, the handle can be swivelled through 90° to the left or right.
Do not use the throttle during this operation!
Proceed as follows:
Free the rear handle by pressing the locking lever (2).
Turn the rear handle until the locking lever clicks into place.
When the handle is locked in its new position you can apply the throttle again (1)
NOTE