Operator`s manual

HT60D / HT70S Hedgetrimmer

Original Instructions Version Mar12

While holding the unit rmly, pull out the starter rope rmly until engine res

(indicated by a cough from the engine).

Move the choke lever (a) to the open position (c) Fig 2.

Pull the starter rope until the engine starts.

Allow the engine to warm up before use. When cutting, always use the hedge trimmer on full throttle.

Hot Engine Starting

Set the ignition switch (b) to the start position “I” (d) Fig 3.

Pull the starter rope until the engine starts.

If the engine does not start after 5 pulls, use the cold start procedure.

Overchoking

Should the engine become ooded due to overchoking, turn the ignition switch o, unscrew the spark plug,

wipe it dry or replace, pull the recoil starter several times without the spark plug in place and with choke in

the open position. This will help clean and ventilate the combustion chamber.

NOTE