Operator`s manual

266LRH / 268LRH Hedgetrimmer

Original Instructions Version June13

Storage

• Remove the spark plug, pour a small amount of oil into the cylinder. Rotate the crankshaft several

times using the starting rope in order to distribute the oil. Put the spark plug back in.

• Remove the fuel from the machine.

• Check the hedge trimmer for damage or problems at the intervals shown below.

Blades

• Remove the fuel from the machine.

• After each session of operation, oil the cutting blades with light chain oil.

• If gap exists between upper and lower blades, adjust them so they are closer together, this is

achieved by loosening the top lock nut, screw the blade bolt in until a snug t and then loosen

blade bolt ½ turn.

• Hold the blade bolt from turning and tighten the lock nut.

• Ifyoufeelthatyouwillnotbeabletoadjustthebladescorrectly,youshouldtakethe

hedge trimmer to an authorised repair agent.

Gearbox Lubricant

• Always be sure to use lithium based grease.

• DO NOT force grease into the gear box, apply 2 or 3 pumps of grease every 15 hours of operation.

Grease Fittings