www.mitoxgm.co.
66LRH / 268LRH Hedgetrimmer Component Location 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. Fuel tank – 2 stroke mixture Engine starter. Carburettor / air filter. Safety lever. Throttle control lever. Ignition switch. Harness hanger. Transmission shaft. Gear box. Cutting blade. Rubber hand grip PRODUCT DESCRIPTION This Hedge Trimmer is a 2 stroke fast running power tool and is designed to be used in a domestic application for trimming new growth on hedges.
266LRH / 268LRH Hedgetrimmer Warnings in the Manual This mark indicates instructions which must be followed in order to prevent accidents which could lead to serious bodily injury or death. ! IMPORTANT This mark indicates instructions which must be followed or it leads to mechanical failure, breakdown, or damage. NOTE This mark indicates hints or useful directions in the use of the product. Safety Symbols (1) Read operator’s instruction book before operating this machine.
266LRH / 268LRH Hedgetrimmer (5) Directive 2000-14/CE. Guaranteed noise levels. (6) Danger: risk of exhaust fumes intoxication. Taking Care of Warning Labels Always keep warning labels clean and free of scratches, which might make them illegible or difficult to read. If the warning labels provided with your hedge trimmer become damaged, peel off, or otherwise become illegible or difficult to read, order new labels from the authorised servicing dealer and replace the damaged labels.
266LRH / 268LRH Hedgetrimmer Safety Precautions Introduction Read this Owner/Operator Manual carefully. Be sure you understand how to operate this hedge trimmer properly before you use it. Failure to do so could result in serious injury. Keep this manual handy so that you may refer to it later whenever any questions arise. Also note that you are able to contact the dealer from whom you purchased the product for assistance.
266LRH / 268LRH Hedgetrimmer Never use the Hedge Trimmer in conditions as described below: When the ground is slippery or when other conditions exist which might make it difficult to maintain a steady posture while using the hedge trimmer. At night, at times of heavy fog, or at any other times when your field of vision is limited and it would be difficult to gain a clear view of the area where the hedge trimmer is to be used.
266LRH / 268LRH Hedgetrimmer Never hold the hedge trimmer in a way in which the blades are pointing towards someone else. Never allow the blades to come into contact with your body. Always turn off the engine before adjusting the hedge trimmer, removing branches which have become stuck in the blades, or at any other time when coming into close proximity with the blades. Always wear thick work gloves when adjusting the hedge trimmer. Always place the blade cover provided over the blades when not in use.
266LRH / 268LRH Hedgetrimmer Before Operating the Hedge Trimmer Before beginning work, carefully check the work area and remove any obstacles. Within a perimeter of 15 metres of the work area should be considered a hazardous area into which no-one should enter while the hedge trimmer is being used, and when necessary this area should be marked with a warning rope, warning signs, or other forms of warning.
266LRH / 268LRH Hedgetrimmer Avoid Noise Problems Check and follow the local regulations for sound levels and hours of operation for garden machinery. In general, operate hedge trimmers between 8 am, and 5 pm on week days and 9 am to 5 pm at weekends. Avoid using the hedge trimmer late at night and/or early in the morning.
266LRH / 268LRH Hedgetrimmer Two-Stroke Fuel Fuel is very flammable. Do not smoke or bring any flame or sparks near fuel. Always stop the engine and allow it cool before refuelling. Refuel outdoors on bare ground, restart the engine at least 5m away from the refuelling stop. The engine is lubricated by oil mixed into petrol. Prepare a mixture of unleaded petrol and semi-synthetic two-stroke oil that meets the specifications of: API TC, ISO-L-EGC, JASO FC (Low Smoke) oil. Recommended mixing ratio is 40:1.
266LRH / 268LRH Hedgetrimmer Fuel Storage Mixed two-stroke fuel which has been left unused for a period of one month or more may damage the carburettor and result in the engine failing to start or operate correctly. When storing the hedge trimmer for a period of more than one month, empty the fuel tank, and run the engine to empty the carburettor of fuel. Two stroke fuel can cause deterioration of rubber and/or plastic components during prolonged storage.
266LRH / 268LRH Hedgetrimmer Attaching the Hedge Trimmer Head 4 6 3 5 1 2 1. 2. 3. 4. 5. Remove the locating screw (1). Using a 4mm Allen key, loosen the clamping bolt (2). Slide the drive shaft (3) into the hedge trimmer gearbox (4) until the locating hole (5) in the drive shaft is visible though the locating hole (6) in the gearbox. Insert the locating screw (1) into the gear box (6) and tighten. Using a 4mm Allen key, tighten the clamping bolt (2).
266LRH / 268LRH Hedgetrimmer Fitting the Handguard Hedgetrimmer attachments are supplied with a hand guard, which prevents the operator from acidentally touching the hedgetrimer blades. On 281-MT models this guard also acts as a clip where the tip of the blades can be secured when the hedgetrimmer is folded for storage. blade clip nut to cutter head allen bolt To fit the hand guard, slide it over the driveshaft and secure in place using the allen key bolt and nut supplied.
266LRH / 268LRH Hedgetrimmer Operation Keep clear of the blades as they may start moving when engine starts. Starting the Engine CAUTION do not pull the starter cord all the way out and do not let go of the starter handle when the cord is extended, this can damage the starter mechanism. Cold Engine Starting Rest the unit on a flat, firm surface. Keep the blades off the ground and clear of surrounding objects as they may start moving upon starting of the engine.
266LRH / 268LRH Hedgetrimmer • • • • • • • Release the throttle control lever first and then release your hand. Slowly pull the recoil starter handle until engagement of the pawls with the flywheel is felt. While holding the unit, pull out the starter rope firmly until engine fires (indicated by a ‘cough’ from the engine). Move the choke lever to the open position. Pull the starter rope until the engine starts. Pull and to release the fast idle control to return the engine to idle (268LRH).
266LRH / 268LRH Hedgetrimmer Running In During the first ten hours of work, avoid running the engine at maximum speed for a prolonged period until all the components have bedded in, after the engine has been run in, it will reach its maximum power. Transportation Never transport the hedge trimmer with the engine running. An engine that is running could be accidently accelerated causing the blade to engage. Make sure the blade safety guards are in place when transporting the hedge trimmer.
266LRH / 268LRH Hedgetrimmer Spark Plug Poor starting or misfiring is often caused by a fouled or defective spark plug, clean and reset the gap to 0.65 mm, or replace the spark plug with NGK: BPRM7A as necessary. Air Filter Before using the hedge trimmer, check the air filter (a). Being clogged, will reduce the engine performance. Remove the air filter cover by undoing the cover screw clean the filter element in warm, soapy water, dry completely before installing.
266LRH / 268LRH Hedgetrimmer Storage • • Remove the spark plug, pour a small amount of oil into the cylinder. Rotate the crankshaft several times using the starting rope in order to distribute the oil. Put the spark plug back in. Remove the fuel from the machine. • Check the hedge trimmer for damage or problems at the intervals shown below. Blades • • • • • Remove the fuel from the machine. After each session of operation, oil the cutting blades with light chain oil.
266LRH / 268LRH Hedgetrimmer Troubleshooting Engine will not start, power loss: • • • • • • Check that the fuel tank is not empty. Fill with mixed fuel. The fuel does not reach the carburettor. Change the fuel filter in the fuel tank. There is water in the fuel. Drain and clean the fuel system. The air filter is dirty. Clean or replace the air filter. There are carbon deposits in the exhaust muffler restricting the engine. Clean or change the muffler. Spark plug is worn. Replace spark plug.
266LRH / 268LRH Hedgetrimmer Service Schedule Component Procedure Fuel Leaks / Fuel Spillage Clean Up Fuel Tank.
266LRH / 268LRH Hedgetrimmer Specifications MODEL MITOX 266LRH 268LRH Engine Transmission Type Air cooled 2-stroke gasoline engine Model IE34F-2E Displacement : ( cm3) 25.4 cc Max. output 0.7 (kw) in accordance with ISO 8893 Idle speed: rpm (min –1) 2800±150 Max. power speed: rpm (min –1) 9800 Fuel tank capacity 0.
266LRH / 268LRH Hedgetrimmer 22 Original Instructions Version June13
266LRH / 268LRH Hedgetrimmer Original Instructions Version June13 23
266LRH / 268LRH Hedgetrimmer 24 Original Instructions Version June13
266LRH / 268LRH Hedgetrimmer Original Instructions Version June13 25
6LRH / 268LRH Hedgetrimmer 26 Original Instructions Version June13
266LRH / 268LRH Hedgetrimmer Original Instructions Version June13 27
266LRH / 268LRH Hedgetrimmer CONDITIONS OF WARRANTY The manufacturer warrants the product against faulty materials and workmanship for a period of 2 years from the date of first purchase. The warranty is applicable when the product is used in a “home owner” application. If products are used for commercial or professional purposes, the warranty period is for 3 months from the date of first purchase. Warranty does not extend to failure due to fair wear and tear.
