Technical information

Table of Contents
ix
Tables
Table 1: Firmware Commands ................................................................ 35
Table 2: Summary of Fields in Trunk SMDR Records ............................. 42
Table 3: Main Control Card Error Code Summary ................................... 56
Table 4: SX-200 SPINE Maximum Receiver Combinations
Available .................................................................................... 68
Table 5: Maximum Number of T1 Trunk Cards Prior
to LIGHTWARE 18 .................................................................... 72
Table 6: Loop Start Line/Trunk Summary ................................................ 74
Table 7: Ground Start Trunk Summary .................................................... 76
Table 8: Direct Inward Dial/Loop Trunk Summary ................................... 79
Table 9: E&M Trunk Summary ................................................................ 82
Table 10: A-B Signalling States (Tie/E&M) ................................................ 87
Table 11: A-B Bit Signalling Example (T1/CO) .......................................... 88
Table 12: PMS Keyboard Commands ....................................................... 91
Table 13: Floppy Disk Troubleshooting Summary ..................................... 94
Table 14: Floppy Disk Drive Error Code Summary .................................... 95
Table 15: SX-200 IP Node Troubleshooting Table .................................... 98
Table 16: Test Line Command Codes ..................................................... 105
Table 17: Test Line Status Indicator Codes ............................................. 106
Table 18: Test Line Status Tones ............................................................ 107
Table 19: ANI/DNIS Digits on Phone Display (COS Option 502
Enabled and COS Option 613 Disabled) ................................. 132
Table 20: ANI/DNIS Digits on Phone Display (COS Option 502
Enabled and COS Option 613 Enabled) .................................. 133
Table 21: ANI/DNIS for ACD Agents ....................................................... 133
Table 22: Feature Access Codes ............................................................ 148
Table 23: Class of Service Options ......................................................... 151
Table 24: LIGHTWARE 19 Release 2.0 and greater System
Options and Timers ................................................................. 159
Table 25: Feature Limitations .................................................................. 166
Table 26: SX-200 SPINE Configuration Rules ........................................ 179
Table 27: Cable Assignments for SX-200 DIGITAL Cabinets ................. 184
Table 28: Main Control Card Codes ........................................................ 194
Table 29: Main Control Card Test Status Codes ..................................... 195
Table 30: Main Control Card Power-Up Error Code Summary ................ 196
Table 31: Peripheral Interface Cards and Modules ................................. 199
Table 32: Digital Control and Digital Services Cards and Modules ......... 202
Table 33: E&M Trunk Module Switch Settings ........................................ 204
Table 34: Control Resource Card Switch Setting .................................... 206
Table 35: BRI Port to Tip/Ring Assignment ............................................. 211
Table 36: SFT Port (J7) ........................................................................... 212
Table 37: Music-on-Hold/Pager Unit Pinouts ........................................... 212