Technical information

Technician’s Handbook
38
7. Choose a location for the installSetup program to install files
(normally this is C:\intpub\ftproot). The installSetup program provides
a progress indicator and a log file.
8. Click Finish when prompted.
You are presented with a text file providing instructions.
9. Launch a data communication application, such as Hyperterminal on
the PC.
10. Specify the PC COM port that is connected to the SX-200 IP Node
Maintenance port.
11. Set the communication parameters: 9600, 8, N, 1, None.
12. Enter “reboot” to reboot the SX-200 IP Node.
13. Press a key at the "Press any key to stop auto-boot" prompt to stop
the auto-boot.
14. At [VxWorks Boot] type “c” and then press Enter.
15. Change the following parameters as indicated:
- Boot device : motfcc
- File name : Lite_Install
- Host inet : <the IP address of the ftp server PC host (your PC)>
- User (u) : <user name for FTP server in PC host>
- Ftp password (pw) (blank = use rsh) : <password for FTP server in
PC host>
- Flags (f) : 0x0 (this is the default setting and should not have to be
changed).
16. Press the reset button on the SX-200 IP Node, or at the PC, enter "@"
to reboot the SX-200 IP Node.
The software installation takes about 10 minutes. The SX-200 IP
Node reboots two times.