Technical information

Routine Maintenance
37
Upgrading an SX-200 IP Node
Upgrading from CD-ROM
.
Installer's PC requirements
 Windows NT 4.0 or Windows 2000 operating system
 FTP server running (with IIS installed)
 A communications program such as VT100 or HyperTerm
 A serial connection to the SX-200 Maintenance port
 Windows 2000 users must clear the browser cache.
You also need
 The IP address of the SX-200 IP Node. The IP address must also be
correctly programmed before you begin. For more information, see
“Initializing the SX-200 IP Node” on page 137.
 SX-200 IP Node software CD-ROM
 Time: The entire upgrade procedure takes approximately 20 minutes.
To upgrade the Sx-200 IP Node software
1. Connect both the PC and the SX-200 IP Node to the LAN.
2. Connect the serial cable from the PC to the Maintenance Port on the
SX-200 IP Node.
3. From your PC, ping the SX-200 IP Node to verify that you have a
TCP/IP connection.
4. Insert the Mitel Networks SX-200 IP Node software CD-ROM into the
CD drive of the installer's PC.
5. Run the "Setup.exe" program from the CD.
6. Select New Installation.
The upgrade procedure will install new software in the
IP Node.