Technical information

Routine Maintenance

SX-200 EL/ML Flash Memory Card Replacement

1. Back up the database.

2. Power down the Control cabinet.

3. Remove the flash memory card and install the new flash

memory card. Make sure the toggle switch on the edge opposite the

connector edge of the Flash card has the Write Protect disabled.

After installing the card, look at the facing edge. You should see the

switch in the down position.

4. Power up the system.

5. Enable new options if new feature options have been purchased.

Refer to Backing Up a Customer Database (page 27).

Refer to Powering Down the Nodes (page 60).

Refer to Powering Up the Nodes (page 61).

Refer to Enabling Options or Changing Options (page 36).