Technical information

Installation
197
Note: 1. The SX-200 LIGHT system must be equipped with the Switch Matrix
Module instead of the DX Module used in the 336, 456 & 480-port sys-
tems or the Switch Matrix Card used in the 672 -port system.
2. A normal running system may show other codes (card diagnostics or er-
rors). However, during start-up, only the codes in this table are possible.
Any other code shown during start-up indicates a faulty Main Control
Card.
3. Codes possible AFTER start-up include card diagnostics codes (last
card location tested, top number indicates bay number, bottom number
indicates card slot number - maintenance logs give results of test, i.e.,
pass or fail with cause), or disk error codes.
23456or 7
000000
• Problem in a digital bay/node - upper digit is the
bay number. Refer to Bay Control Card
procedures.
234567
nnnnnorn
(where n is any number)
• Problem in a peripheral bay/node - upper digit is
the bay/node number, lower digit is the card slot
number. Use SHOW ALARMS command to gain
further information (see note 2).
E.
n
(where n is any number)
• Note difference between “E” and “E.”
(see above in this table for “E” codes).
• Problem with Disk Subsystem - refer to Floppy
Disk Subsystem Troubleshooting.
-
-
• Nothing - indicates successful software download.
This display may be immediately changed to
display post boot-up codes (see note 2).
(any other code)
• Faulty Main Control Card (see note 2).
Refer to SX-200 LIGHT/DIGITAL Floppy Disk Subsystem
Troubleshooting Procedures (page 99).
Table 30: Main Control Card Power-Up Error Code Summary
(continued)
Error Code Likely Cause(s)
(Sheet 2 of 2)