Technical information

Technician’s Handbook
146
6. Form 19, Call Rerouting: program “Station Dial 0" routing
 The “Station Dial 0" answer point for all tenants must be a
Console LDN or Subattendant LDN. To allow the customer’s
PMS to set message waiting, you must program Day, Night 1,
and Night 2 answer points to the same LDN.
 If you require different “Dial 0" answer points for Day, N1, and N2
use “Priority Dial 0" as an alternate method.
7. Form 34, Directed I/O: program the PMS.
8. Connect the Dataset to the programmed PLID.
 All three Dataset LED’s should light. If not, verify your
programming and hardware connections.
9. Connect the customer’s PMS computer to the Dataset’s RS-232
connector.
10. Verify that the customer’s PMS computer communicates
with the PBX.
 If the PBX’s PMS interface and the customer’s PMS computer
communicate properly, you will see an exchange of ENQ
(Enquire) and ACK (Acknowledge) commands at the customer’s
PMS computer.
 If the PBX’s PMS interface and the customer’s PMS computer do
not communicate properly, test the PBX’s PMS interface.
[ Tenant _____ ] Type Of Call Day N1 N2
Station Dial 0 Routing Same LDN Same LDN Same LDN
EXT NUM PRINTOUT PRINTOUT TYPE GUARANTEED
From Form 12 PMS AUTOPRINT NO
Refer to PBX and PMS Cannot Communicate (p. 91).