Manualshelf

Technical information

ManualsBrandsMitel ManualsConsumer electronicsSX-2000 ML
151152153154155156157158159160
Programming
139
5. Form 13 - Trunk Circuit Descriptors
Set a descriptor to T1 E&M.
Set Incoming Start Type to WINK.
Set Outgoing Start Type to WINK.
Set QSIG Supplementary Services to YES.
6. Form 15 - Dial-in Trunks
In the CDN Field, enter the descriptor number for T1 E&M that is
specified in Form 13.
7. Form 16 - Trunk Groups
Assign Trunk Groups to IP Trunks. All IP Trunks must be
programmed in the same Group. To avoid collisions, program the
trunks in reverse order at each end.
8. Program Form 26 - ARS: Digit Strings.
9. Program Form 22 - ARS: Modified Digit Table.
10. Program Form 23 - Route Definition.
Specify the routes of IP Trunk Groups.
In Subform 23 - Show IP, specify the destination IP Node Number
for each route.
11. Form 47 - IP & DCHP Parameters
Enter the IP Controller Address. Enter the SX-200 IP Node
address.
Enter the DHCP Server Subnet.
Enter the DHCP Server Subnet mask.
Enter the DHCP Assignable IP Address Start. Enter the start
range of the IP phones.
Enter the DHCP Assignable IP Address End. Enter the end range
of the IP phones.
Enter the TFTP Server Address. Enter the IP address of any
SX-200 IP Node.
Enter the Gateway/Router IP Address.