Technical information

Table 1: Firmware Commands ....................................................35

Table 2: Summary of Fields in Trunk SMDR Records ................42

Table 3: Main Control Card Error Code Summary ......................56

Table 4: SX-200 SPINE Maximum Receiver Combinations Available

Table 5: Maximum Number of T1 Trunk Cards

Prior to LIGHTWARE 18 72

Table 6: Loop Start Line/Trunk Summary ...................................74

Table 7: Ground Start Trunk Summary .......................................76

Table 8: Direct Inward Dial/Loop Trunk Summary ......................79

Table 9: E&M Trunk Summary ....................................................82

Table 10: A-B Signalling States (Tie/E&M) ...................................87

Table 11: A-B Bit Signalling Example (T1/CO) .............................88

Table 12: PMS Keyboard Commands ...........................................91

Table 13: Floppy Disk Troubleshooting Summary ........................94

Table 14: Floppy Disk Drive Error Code Summary .......................95

Table 15: SX-200 IP Node Troubleshooting Table .......................98

Table 16: Test Line Command Codes ........................................105

Table 17: Test Line Status Indicator Codes ................................106

Table 18: Test Line Status Tones ...............................................107

Table 19: ANI/DNIS Digits on Phone Display

(COS Option 502 Enabled and COS Option 613 Disabled) 132

Table 20: ANI/DNIS Digits on Phone Display

(COS Option 502 Enabled and COS Option 613 Enabled) 133

Table 21: ANI/DNIS for ACD Agents ...........................................133

Table 22: Feature Access Codes ................................................148

Table 23: Class of Service Options .............................................151

Table 24: LIGHTWARE 19 Release 2.0 and greater

System Options and Timers 159

Table 25: Feature Limitations ......................................................166

Table 26: SX-200 SPINE Configuration Rules ............................179

Table 27: Cable Assignments for SX-200 DIGITAL Cabinets .....184

Table 28: Main Control Card Codes ............................................194

Table 29: Main Control Card Test Status Codes ........................195

Table 30: Main Control Card Power-Up Error Code Summary ...196

Table 31: Peripheral Interface Cards and Modules .....................199

Table 32: Digital Control and Digital Services Cards and Modules ...

202

Table 33: E&M Trunk Module Switch Settings ............................204

Table 34: Control Resource Card Switch Setting ........................206